Part 4 of the LS Wiring Harness Cleanup will cover troubleshooting left over wires, taping up the new harness, extending some of the wires that are being retained, and prepping for installing the fuse harness.

The goal is to create a Stand a Lone harness that only requires 4 wires to run the engine. There will be additional wires running to the vehicle to support additional features.

Project Rowdy is a restoration on a 1979 Jeep CJ7. This LS Swap Harness is being prepared to be mated back to its original engine: 2001 Chevy Silverado 5.3L LM7 which has just undergone a full rebuild.

References:
Wiring Harness Research: http://www.LT1Swap.com
Wiring Cleanup Procedures: To be published after revisions from this current build
LS Fuse Block and Relay Diagram: http://bit.ly/LS_Harness_Diagrams
PCM and Connectors Pinout Charts: http://bit.ly/PCMandConnectorTables

Tools and Parts used:
Qiorange 8 Pin Connector: http://amzn.to/2lNgMW8
Doorman Fuse Block: http://amzn.to/2kOBR2R
eTing 5 Pin Relay Socket: http://amzn.to/2kOzzRk
Absolute RLS125 Relays: http://amzn.to/2lNp4gR
Vice Grip Wire Strippers: http://amzn.to/2lI3fie
Loom Fabric Tape: http://amzn.to/2xZng69

Project Rowdy Playlist:
   • Project Rowdy  Jeep Restoration  

UCanDoIt2 Website: http://www.ucandoit2.club/
UCanDoIt2 Contact: [email protected]

JeepForum Thread:
http://www.jeepforum.com/forum/f22/pr...

Facebook Page:
  / projectrowdy  

Sorry it took so long to get back to you on the Loom Amounts.... Here is what it took:
1/4" : 16 feet
3/8" : 8 feet
1/2" : 3 feet
11/4": 3.5 feet
The 3 smaller sizes I purchased from Harbor Freight (1 pack each) and the 1/1/4" I found on eBay and purchased 4 feet (by the foot).

Music
Intro: Alex Skrindo (Alive)

#lsswap #lsswaptheworld #lsswapc10 #lsswapc10 #diyperformance #jeep #jeepcj