Part 5 of the LS Wiring Harness Cleanup will cover the installation of the 4 Fuse Block, Main Relay, Fuel Pump Relay, and a custom 8 pin connector to support dash gauges and instruments.

The goal is to create a Stand a Lone harness that only requires 4 wires to run the engine. There will be additional wires running to the vehicle to support additional features.

Project Rowdy is a restoration on a 1979 Jeep CJ7. This LS Swap Harness is being prepared to be mated back to its original engine: 2001 Chevy Silverado 5.3L LM7 which has just undergone a full rebuild.

References:
Wiring Harness Research: http://www.LT1Swap.com
Wiring Cleanup Procedures: To be published after revisions from this current build
LS Fuse Block and Relay Diagram: http://bit.ly/LS_Harness_Diagrams
PCM and Connectors Pinout Charts: http://bit.ly/PCMandConnectorTables

Tools and Parts used:
Qiorange 8 Pin Connector: http://amzn.to/2lNgMW8
Doorman Fuse Block: http://amzn.to/2kOBR2R
eTing 5 Pin Relay Socket: http://amzn.to/2kOzzRk
Absolute RLS125 Relays: http://amzn.to/2lNp4gR
Vice Grip Wire Strippers: http://amzn.to/2lI3fie
Loom Fabric Tape: http://amzn.to/2xZng69
Here is what I used for the wiring:

Pink (AWG18) This was reused from the original harness
Yellow (AWG16) Fuel Pump Feed
Red (AWG10) Battery Hot
Purple (AWG10) Keyed Hot

Project Rowdy Playlist:
   • Project Rowdy  Jeep Restoration  

UCanDoIt2 Website: http://www.ucandoit2.club/
UCanDoIt2 Contact: [email protected]

JeepForum Thread:
http://www.jeepforum.com/forum/f22/pr...

Facebook Page:
  / projectrowdy  

Wire Loom Amounts:
1/4" : 16 feet
3/8" : 8 feet
1/2" : 3 feet
11/4": 3.5 feet
The 3 smaller sizes I purchased from Harbor Freight (1 pack each) and the 1/1/4" I found on eBay and purchased 4 feet (by the foot).

Music
Intro: Alex Skrindo (Alive)

#lsswap #lsswaptheworld #lsswapc10 #lsswapc10 #diyperformance #jeep #jeepcj