Call 8312448080 for questions

We show How the Ultrasonic Flow Meters can be "calibrated" or "linearized" to fit your specific application. This method is used when the fluid or the installation is nonideal, such as valves, elbows, or reducing or increasing pipe sizes are used. We show using a 7 element linearizer to compensate for an exemplarily application. The units of the linearizer in m3/h to "speak" the "raw language" of the flow meter. You will want to convert YOUR flow to m3/h and then you may use any units you wish once the linearization is done, such as GPM.

These are also called Ultrasonic Transit Time flowmeters and clamp on flow meters.

These are commonly used as Ultrasonic flow meters for water and they are low cost compared to meters that require cutting into the pipe.

The MAJOR BENEFIT is you can clamp these on the outside of your existing pipe without any penetrations.

Tactical Flow Meter Ultrasonic Flow meters features LARGE LCD display, shows the Instantaneous Flow Rate, Total Flow, in user selectable units.

Specifications
Medium: Any acoustically conductive fluid with less than 5% air bubbles or solids
Pipe size: ¼” to 240”
Flow rate: 0 200 GPM, guessing….
Temperature: 20 110 ℃
Transducer material: Aluminum and 304 SS
Cable length: 8’ to 20' nominally
Accuracy: ±1% from 0.15 to 40 f/s (0.05 to 12 m/s)
Resolution: 0.01 ft/s (0.00025 m/s)
Response time: 150 ms measuring cycle typical
Transducer Frequency: 1 MHz
Clampon transducers: encapsulated design IP68
Enclosure Protection Grade: IP65
Display LCD Screen
Power Supply: 24VDC or 86240 VAC Universal Power Supply
Output: 420mA + 010K Hz + Standard ModBus RTU Communication protocol
Note: For 1 to 5 VDC output, add 250 Ohm resistor to 4 to 20 mA loop.

View full spec sheet here.
https://www.tacticalflowmeter.com/pro...

Please like this video and subscribe to our channel if this video helped you.