We FINALLY got a tube bender! And after doing our research, we decided on the Model 600 from Rogue Fabrication! Naturally, we opted for the weld together kit and in this video we take you though the entire assembly from start to finish. This is not a replacement for Rogue Fab's instructions, but a helpful visual aid to get you though the process after buying your own, and to show you just how easy it is to put together yourself.

If you are looking to invest in a 180°+ tubing bender, there is no better value than the M600. Check it out on their website www.roguefab.com

Model 600 Tubing Bender
https://tinyurl.com/y4dgcdax

**SIDE NOTE**
We are using a 3.5 CLR die and so the pressure die pin SHOULD have been in the top most hole, not the middle like we had it on camera. This allows the tube you are bending to to be horizontal when starting your bend, not on an angle like you see here. With the stickers installed after paint, you'll probably never make the same mistake!