OUT OF STOCK. ANTICIPATING BEGINNING OF DECEMBER FOR RESTOCK FOR COLOR OPTIONS. 2ND/3RD WEEK OF NOVEMBER FOR RAW ALUMINUM NEW BATCH IS A V2.0 . MADE FROM AIRCRAFT GRADE 7075 ALUMINUM

When you lift a kdss 4r or gx the outer bushings for the front sway bar gets into a really bad angle! It’s binded up pretty bad and will prematurely wear down. This bracket correct the angle and inherently allows full droop in your suspension when you have long travel or extended travel setup.

Can not be combined with front KDSS drop spacer!

Designed for 1.5” 3.5”+ suspension lift on kdss equipped 201022 4runner / gx460 / prado

Benefits:
keeps the sway bar up nice and high away from skid plate
corrects the bad bushing angle.
extends the life of bushings.
easier to reinstall when changing bushings.
allows full droop when you have extended travel or long travel setup ( total chaos +2 LT for KDSS).
lightens up the spring rate on the front sway bar.
creates a more stout floor jack point.

Kdss was never designed to have the suspension raised / lifted. When you introduce a suspension system that raises the ride height, the bushing(s) at the lower control arm(s) get into a bad angle and the bushing(s) binds up. This accelerates the wear of the bushing(s) which eventually you will have metal on metal contact with the sway bar and bushing mount. These KDSS sway bar end adapters correct that bad bushing angle.

Inherently, when a suspension or lift kit is added , the shocks allow for a more travel … ie extended travel and or long travel. As the front suspension is raised or it droops out under the suspension cycle , the front kdss sway bar swings back towards the motor. If you have enough suspension down travel, the hard link not only gets into a bad angle, it also will contact the frame in some cases, putting your down travel to a dead stop as the system can no longer swing back. The passenger side will run out of down travel because of the fixedlength link. The driver's side doesn’t because it has a shock that can extend down. These KDSS bushing adapters push the sway bar forward away from the frame so there’s no contact at full droop.

Factory bushing bracket bottom hooks must be cut off.

Buy: https://bit.ly/3OAXgWW

If you have any questions: https://drkdss.com/pages/contact