This video highlights modifications and the installation of the Titan Fitness Wall Mounted Pullup Bar.

If you would like to support the channel in a monetary way; here are some ways:
PayPal: https://paypal.me/sdanderson21
Venmo: https://www.venmo.com/u/sdanderson21

To purchase from Amazon: https://amzn.to/2L0tX4D

The modifications highlight yielding the areas around the mounting holes with a 4" Cclamp in order to make the mounting surface flat.

The installation highlights changing out the lag screws with 3/8" instead of the 5/16" lag screws that are supplied. As well as changing out the washers for the appropriate line screw diameter.

Pilot holes were drilled before torquing down the lag screws. I stepped up my pilot holes with three different diameters using the first drill bit of 9/64" then using a 3/16" and then finally arriving at a 1/4" pilot hole. The step up was used to ensure that I had a straight pilot hole to avoid splitting the studs.

I earn commissions from these links.