Carefully read the manual and follow the steps for your safety.

Dilution:
* 10ml/L Thermal Fogging Outdoor
* 20ml/L Thermal Fogging Indoor

1. Chemical mix
Detach main body fogger from the chemical tank
Filling solution (diesel + chemical) into chemical tank.
2. Starting
connect the butane gas into the gas connector.
be sure to connect the gas cylinder while the valve is closed.
open the gas control valve.
Press the ignition.
preheat the coil. Wait for 20 sec. after ignition.
3. Discharging Fog
Pump the pumplever for 2 to 3 time.
When the solution output is lower, pump it again.
Do not interrupt the smoke screen during the smoke screen operation
If the work is interrupted, the coil will burn causing the nozzle to clog. So work little by little when moving to another area.
4. Stopping
After working, close the gas control valve.
Pump the pump lever for 5~6 times to eliminate the remaining chemical in the coil and ejection nozzle.
5. Special prevention of coil clogging
Detach main body of fogger from the tank after its use, and fill water in a plastic bottle/container, with ignition on. Put Cylinder in the water, and remove the residue in the coil by pumping fogger fast about a minute, until vapor is emitted. By doing this all the residue will be removed.
6. Maintenance after use
Chemical tank , gas and main body should be kept separately.
Soak pump in the water so that it will immersed, and you can clean the chemical tank by spraying water.

*Warning: Please use safety gears like mask and gloves while performing the machine for your safety. And Keep out from children's reach.

For Inquires:
FB page   / safetyno1cebu  
Instagram   / safety_no1  
Lazada https://www.lazada.com.ph/shop/safety...
Shopee shopee.ph/safety_no1_online_shop
Email [email protected]
Contact # (032) 410 4271 / 09163758711