https://www.dfwfencecontractor.com/fe... Installing Cedar Board on Board Fence step and level. Using postmaster fence posts.
8178860848

Building a wooden step fence on a slope while ensuring the top is level requires careful planning, precise measurements, and proper construction techniques. Here's a detailed guide on how to build a step fence on a slope while maintaining a level top:

Materials Needed:

Pressuretreated wooden posts
Wooden rails or stringers
Wooden pickets or panels
Gravel or crushed stone
Concrete mix
Nails or screws
Level
Tape measure
Shovel
Post hole digger
Circular saw or handsaw
Hammer or screwdriver
StepbyStep Construction:

Plan the Fence Layout:

Start by determining the layout of your fence, taking into account the slope of the terrain. Consider the desired height of the fence and the number of steps needed to navigate the slope.
Mark the locations for the fence posts along the slope, ensuring they are evenly spaced and aligned. Use stakes and string to establish a straight line for the fence.
Dig Post Holes:

Use a posthole digger to excavate holes for the fence posts at each marked location. The depth of the holes should be determined by the height of the fence and the depth required for stability.
On slopes, the depth of the holes on the uphill side should be deeper than those on the downhill side to accommodate for the angle of the slope.
Install Fence Posts:

Place a layer of gravel or crushed stone at the bottom of each post hole for drainage.
Insert the pressuretreated wooden posts into the holes, ensuring they are plumb and level. Use a level to check for vertical and horizontal alignment.
Fill the holes with concrete mix, tamping down the concrete to remove air pockets and ensure stability. Allow the concrete to cure according to the manufacturer's instructions.
Attach Rails or Stringers:

Once the concrete has cured, attach wooden rails or stringers horizontally between the fence posts, starting at the bottom of the slope and working your way up.
Use a level to ensure that each rail is straight and level. Adjust the height of the rails as needed to accommodate the slope of the terrain.
Secure the rails to the posts using nails or screws, ensuring they are firmly anchored in place.
Install Pickets or Panels:

Once the rails are in place, attach wooden pickets or panels vertically to the rails, creating the desired height for the fence.
Space the pickets or panels evenly along the length of the fence, ensuring they are securely fastened to the rails.
Use a level to check that each picket or panel is plumb and level, adjusting as needed to maintain a uniform appearance.
Create Steps:

If the slope is steep, consider incorporating steps into the design of the fence to make it easier to navigate.
Cut wooden steps from pressuretreated lumber, ensuring they are wide enough and spaced evenly along the length of the fence.
Attach the steps to the rails or stringers using screws or nails, ensuring they are securely anchored in place.
Level the Top:

Once the fence is fully constructed, use a level to check that the top of the fence is level across its entire length.
Make any necessary adjustments by raising or lowering individual posts or rails as needed to achieve a level top.
Finishing Touches:

Once the top of the fence is level, trim any excess length from the posts or pickets if necessary.
Apply a protective finish, such as stain or paint, to the wooden fence to enhance its appearance and durability.
Add any desired decorative elements, such as finials or postcaps, to complete the look of the fence.
By following these detailed steps and ensuring careful attention to measurements and alignment, you can successfully build a wooden step fence on a slope while maintaining a level top. This will result in a sturdy and visually appealing fence that enhances the beauty and functionality of your outdoor space.

www.dfwfencecontractor.com