Secret sauce that brings YouTube followers, views, likes
Get Free YouTube Subscribers, Views and Likes

Jeep 4 0L: Cam Lifters and Timing Chain. Part 2/2

Follow
FreedivejeepHD

Putting the Jeep 4.0L all back together, as well as upgrading to Harland Sharp roller rockers. Shortcuts listed below.
0:04 Preparing camshaft for installation
2:02 Thrust plate installation
4:32 Removing old crankshaft seal from timing cover
5:05 Crankshaft seal installation
6:26 Timing gears and chain installation
8:32 Harmonic balancer and timing cover installation
15:13 Preparing engine block surface for new head gasket
18:07 Lifter installation
22:31 Head gasket installation
24:22 Freeze plug installation
25:38 Head installation
27:07 Head bolt preparation
30:52 Head bolt tightening sequence
36:34 Painting the head
39:52 Block heater chord installation
40:16 Spark plug replacement
40:50 Intake and exhaust manifolds prep
42:52 Intake and exhaust manifolds installation
48:07 Engine block coolant drain plug installation
48:33 Pushrod check and installation
49:59 Roller rocker installation
53:30 Valve cover gasket prep and installation
54:29 Valve cover installation
59:24 Thermostat housing installation
1:01:43 Fuel injector heat shield installation
1:01:57 Installing electrical rail on head bolts
1:02:30 Fuel injector rail installation and Oring replacement
1:04:28 Electrical rail to intake manifold installation
1:04:50 Throttle body installation
1:05:58 Attaching catalytic converter to exhaust manifold
1:07:13 Installing oxygen sensors
1:07:41 Attaching catalytic converter to muffler
1:08:09 Attaching fuel line to fuel rail
1:09:01 Oil pump drive assembly (OPDA) installation
1:10:53 Establishing Top Dead Center
1:14:12 Coil rail installation
1:15:03 Water pump removal and reinstallation
1:18:06 Heater lines installation
1:18:33 Attaching AC lines
1:20:17 Power steering pump installation
1:20:57 Various sensor and vacuum line installation to intake manifold
1:21:56 Throttle cable and bracket installation
1:22:37 IAC and TPS sensor installation
1:23:29 Grille and body mount installation
1:22:56 Attaching AC lines to AC condenser
1:26:35 Attaching ambient air temperature sensors to grille
1:27:30 Installing headlights and trim surrounds
1:29:50 Cooling fan installation (*install after radiator and fan shroud*)
1:30:24 Radiator installation
1:31:31 Upper radiator hose installation
1:31:55 Alternator, mounting bracket and wiring installation
1:34:28 Fan shroud installation and cooling fan reinstallation
1:35:27 Idler pulley and serpentine belt installation
1:36:52 Electrical ground to head bolt installation
1:38:31 Air box, intake tube and crankcase valve installation
1:40:38 Front differential breather tube installation
1:41:04 Coolant overflow reservoir installation
1:41:32 Grille support bracket installation
1:42:04 Washer fluid reservoir installation
1:42:44 MAP sensor installation
1:44:11 Filling radiator and coolant overflow reservoir
1:44:31 Attaching battery cables
1:44:49 Final oil level check and priming oil pump
1:47:57 Engine start up and breakin procedure
1:49:45 Additional breakin procedures, if desired.

posted by hahljaty7