I make a Campfire Tripod Heating Steel Rebar with a Handheld Propane LPG Gas Burner Torch.

Because I was using 5/8 inch (16mm) Rebar I needed to use a gas burner torch to heat the steel so I could bend it. I enjoy doing blacksmithingtype jobs, it was a very peaceful DIY project, with nowhere near the amount of noise I normally make.

We do quite a bit of outdoor campfire or fireplace cooking and this tripod is a good solid addition to our outdoor kitchen gear.

All the rebar was 5/8 inch (16mm) Except the Hook which was made with 1/2 inch (13mm) Rebar. The height of the campfire tripod, when it is set up, is 43 1/2 inches (110mm).

The main tools used, were a Handheld Propane LPG Gas Burner Torch, MIG welder, angle grinder, and bench vise.

Tools / Supplies, I often use are.

Marking out Tools
Markal SilverStreak Metal Marker Round: https://amzn.to/3mTJDHt
Milwaukee 4pk Inkzall Black Ultra Fine Point Pens: https://amzn.to/2WKKpeE
Milwaukee Inkzall Jobsite Fine Point Black Permanent Marker 12 Pack: https://amzn.to/3kHrXfo

Locking Pliers – Vise Grips
MILWAUKEE 10” Locking Pliers, Curved Jaw: https://amzn.to/3zzJH2u
Milwaukee 6" Long Nose Locking Pliers: https://amzn.to/3jyVLeS
Milwaukee 6” Locking Clamp Regular Jaws: https://amzn.to/3jB94eI
KNIPEX Tools Long Nose Grip Pliers: https://amzn.to/3ByD1SP

Magnets
Magnetic VPads Kit, Magnets On Both Pad Face & Bottom: https://amzn.to/3DCya4W
Mini Magnetic Fabrication Square Magnets Angles: 30°, 60°, 45°, 90°: https://amzn.to/2WN9Fkr
“L” shape Corner Square Magnets 12°, 90° & 60° Angle Setting: https://amzn.to/2YaZXsU

My camera setup.
Canon EOS M6 Mark II Camera 1545mm Lens: https://amzn.to/3DNnn83
VideoMicro Rode Compact OnCamera Microphone: https://amzn.to/3QkUBnK
Camera Tripod Vanguard Alta Pro 2: https://amzn.to/3yB8hP5

The Brand of the Drill bits, and cutting/flap discs, is "Alpha" If you can't get them at your local hardware shop, here is a link to Alpha Tools: https://alphatools.com.au

As an Amazon Associate, I earn from qualifying purchases. This means that if you click on one of the product links, I’ll receive a small commission. This helps support the channel and allows me to continue to make more videos like this one. Thank you very much for your support!

►►Subscribe to our Channel for more videos ►► http://bit.ly/2ULxLJogavinclark
Always use all the correct safety gear, and use your tools safely, I am not a good role model for this.

Hope you found something of use in my video or at least found it entertaining.
Gavin Clark DIY