Hello and welcome to the episode, today im going to show you how to remove and install a high flow air filter on a 2020 Honda NC750X.

Help the channel and Buy Me A Coffee: https://www.buymeacoffee.com/nicksepi...

You dont need an additional tools only the ones provided inside the manufactures tool kit, you will find a screw driver and a Allen wrench

first thing you should do is remove the battery cover as shown

this will allow you to gain access to the lower air filter cover screws

remove the left panel has shown, the front end is clipped in so carefully pull it away giving it a slight wiggle

now do the same for the right side

here you can see it hooks in at the front

next thing you need to remove is the centre panel, this is held in with these plastic push rivets, push them in half way and the rivet will prise up

in total there are 6 holding these on, 3 each side
there is a hidden one inside here

now remove the silver screw on the left

pop out the three rivets on the right side,

now remove the silver screw

lift the left side and make your way to the right

once both sides are lifted now you can pull the centre part towards you because its clipped in under the dials, be careful here move the bars from left to right to wiggle the panel out, the plastic is soft and can flex if you need to.

Here you can see its one complete part


now remove the centre lock panel as shown

remove the centre lock

pop out the air sensor, its only a push fit and will easily come out

here you can see there are 6 screws holding the air filter lid in place

carefully unscrew all of them

now lift out the air filter lid, the filter is attached to the top part

its clipped in you can use a screw driver to pry it out


here is a k and n high flow air filter, if its red in colour then its pre oiled, if not make sure you buy some air filter oil and apply it first

here is the stock filter against the high flow filter

install the parts as shown, be careful not to trap any wires, especially the air flow sensor we pulled out earlier

now push the flow sensor in

install the locks

make sure the cables are not kinked and routed correctly

install the centre panel, clip the front in first then clip in the side section

install the silver screws and then the rivets

clip in the painted panels

install the battery cover

before closing the lid check both locks function correctly using the Allen wrench as shown

Thanks for watching!!

Follow me on socials:
Instagram:   / nicks_episode  

My gear:
Boots: https://www.urbanrider.co.uk/johndoe...
Gloves: https://www.urbanrider.co.uk/johndoe...
Helmet: https://www.infinitymotorcycles.com/p...
Jeans: https://www.ebay.co.uk/itm/2838651207...