I will show you how to make an acrylic led light logo. I am using a 3mm 17inch circle acrylic sheet (you can decide size and shape as per your requirement). I printed out the logo. turned it upsidedown and paste on acrylic using scotch tape. I put the bulb inside the tire table that I made and placed the acrylic on it to see the shadow of logo and started cutting the protection film of acrylic using a knife cutter. I removed the protection film that I cut earlier, be gentle, try not to scratch the acrylic. after removing the protection film, scrub it to give it a logo shape. I am using sand paper, hacksaw blade and sander cone drill bit. Once you are done scrubbing use paint thinner for cleaning and to give it a smoother look. I measured the length of acrylic to design the base. I used 2 inch thick wood lath for the base and 1 inch thick 2 wood laths for holding the acrylic, I spray painted all three wood laths select color as per your requirement. cut the thermocol sheet same size as wood lath that is 17 inch and paste it on both 1inch thick wood laths that will hold the acrylic using a glue gun. paste the led light on wooden base along with thermocol on both sides and then paste the 1inch thick wood lath that will hold the acrylic on thermocol. I covered the logo on acrylic with a scotch or clear tape to protect it from spray paint, and painted the letters below it. I removed the protection film gently and place the acrylic on base and you're done

Remember to leave a Like and Subscribe to the channel
*▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬*

FOLLOW ME ON INSTAGRAM:
  / muhammad_anas_benz  

Like the page on Facebook:
  / wepetrolheads  

Watch DIY customizing tutorials below
   • DIY how to customize car parts  

*Watch events and travelogues below:
   • Travelogues and Events  

Watch car facts and specs videos below :
   • TOP 10 FUN FACTS  

Please email/message me for business inquiries or if you want any video removed.
[email protected]

#acrylic #acryliclogo #ledlight