PLANS AVAILABLE HERE: https://gum.co/IGvmH
For this project I wanted a clean, minimal entertainment unit to go on our feature wall and bring focus to the material rather than the design of the piece itself. I used Oak veneer birch plywood which has a super clean grain so I decided to make the front panel one long piece instead of 3 separate panels.
There is a good amount of storage for devices and I have run HDMI cables through the wall from the TV to inside the unit so there are no visible cables. I also used the bristles from a draught stopper that goes on doors to give a clean cable entry for the soundbar on top that sits on top of the unit.
I used french cleats to hang it onto the walls. Luckily I had a lot of studs in the wall so mounting it was quite easy and it turned out a lot stronger than I expected.
Oak plywood from Plytech:http://www.plytech.co.nz/
Fall flap hinges: https://www.fitnz.co.nz/drawerandd...
_______________________________________________
My Tools:
Dewalt table saw: https://amzn.to/3ackejR
Countersink bit: https://amzn.to/33KaXOK
Music/Ear protection: https://amzn.to/3fKEb2l
Camera: https://amzn.to/31P9sfN
Makita track saw: https://amzn.to/3D7QXVp
Router: https://amzn.to/2PFz5tu
Pocket hole jig: https://amzn.to/3a9E3s0
Mechanical pencil: https://amzn.to/3acH9LH
CA Glue: https://amzn.to/2NvFE49
(Get 15% off using promo code "OFFCUT15" at https://www.starbond.com/?rfsn=296018...)
_______________________________________________
Get my plans: https://gumroad.com/theoffcut
Instagram: / theoffcut_nz
Facebook: / theoffcut
Buy me a coffee: https://www.buymeacoffee.com/theoffcut
Support me on Patreon: / theoffcut