Brake Shoes (low cost): https://geni.us/Yaris_Rear_Shoes_LC
Brake Shoes (Nicer): https://geni.us/Yaris_Rear_Shoes_Best
Drums (if yours are scored due to metalonmetal): https://geni.us/Yaris_Rear_Drums

If you found this helpful, you can say 'Thank You Dan' by buying me a cup of coffee. Thanks SO MUCH!
http://www.buymeacoffee.com/dtdw

Today I'm replacing the rear brake shoes on my Daughters 2008 Toyota Yaris. Check the links for brake shoes and replacement rotors (if necessary), and the other tools and parts required to complete the job. Always put in your exact car model to be sure these parts fit. This process isn't as easy as disk brakes, but it is totally doable with only a few tools.

Note, that if you need to use a bolt to remove the drums, I misquoted it as a 1/420 bolt. It is really a 8mm1.25mm.

Full rebuild kit (brakes, rotor, springs, everything): https://geni.us/Yaris_Rear_Rebuild_Kit

Spring Removal Tool: https://geni.us/Brake_Spring_Tool

The links above are Amazon Associate affiliated which means that without costing you a dime, I get a small commission when you use. Thanks so much for the support!

Dan
[email protected]

0:00 Introduction
1:21 Loosen each lugnut
3:42 Put on gloves
3:54 Spray with brake clean
7:48 First set of gloves
9:21 Use a new cotter pin
14:32 Add grease before assembling
16:08 Second set of gloves...
18:48 Third set of gloves...